I finally replaced a single 470 uF 16V that is on top of the 150 inductor before I had to replace the 3 - 220 uF 16V down in the FET area and lo and behold, the set began working properly again. I then focused the heat down towards the middle of the board on the right side opposite the heat sink and intended to replace them in groups of identical values where the large FETs are.2 - 47uF 50V, then 1 - 1000uF 6.3V and I thought I could tell that the set was responding to less heat. I started with one 100uF 85 C cap up near the power connector but found that not to be the problem.remember I'm leaving in the new caps so this could be a progressive repair. Got my caps in and found the time to start re-capping the signal/main board yesterday. I'm also suspecting that the solder bump RAM chips might have intermittent contacts as I've run into that problem on some laptops I've fixed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |